A 30 000 grain unit is going to use probably 6 8lb of salt maybe more per regen.
Water softener salt level not dropping.
Your water softener may have a salt bridge.
I filled my salt bin up 320 lb and it dropped to half after a month and a half of every 2 nights regeneration but i use 10 11 lb per regen.
The bypass valve is in bypass position.
The initial regen used about 20 lbs of salt judging by the level drop in the tank.
This is common food quality or water softener salt and is usually available in 40 80 lb.
Simply remove the lid to your brine tank and take a look.
A salt bridge is relatively easy to fix.
Remove all the small chunks of salt with a plastic container.
There is a dome of salt with no salt on the bottom.
If you have demand regeneration you re only going to regenerate every 900 1000 gallons of softened water.
Salt water chlorination reduce dosage and re test periodically to prevent level from dropping below 7 salt that is greater than 99 pure.
Turn the water back on and follow the water softener instructions to regenerate your softener.
The water hardness set too low.
As he mentioned it makes 100 sense that a tds meter will measure exactly the same before and after a water softener install since the water isn t being filtered.
Checking the salt level is easy.
Refill the brine tank with salt but no more than 2 3 full.
If you do you should refer to the 1 problem and troubleshooting to fix your system.
If you see water at the bottom of your brine tank it s time to add more salt or regenerant.
6 water softener problems resin beads salt based water softeners use resin beads to enhance their effectiveness.
A salt bridge occurs when the salt at the bottom of the brine tank gets used up but the salt above it does not drop down to be used for the next regeneration.
A salt bridge is caused when pieces of salt are bonded together to create a hard crusty surface on the top of the water in the brine tank.
Check the salt level.
Pull out stem in bypass to valve.
Vacuum out the water in the bottom of the water softener using a wet dry vacuum.
Break the salt bridge.
Unless the salt level in the tank drops considerably to around of the volume of the tank there is little chance to spot water in there.
